The TX7214 Addressable Broadcast Control Module is characterized as one output volt free relay   and control module. The unit is normally used for overriding equipment such as lift return, door holder, smoke extract fans, air handling unit, auto dialler to fire brigade, BMS and etc. The unit according to the pre-configured interface module command fire scenario, the alarm controller send out start command to the equipment required to start. After receiving the command, module enables its relay to change state. Once the module is under control and operated a confirmation signal will be sending back to the alarm controller. In addition, the unit incorporates an intelligent processor that provides automatic monitoring for both open and short circuit of the output signal line.

• EN54-18 Compliance

• Built-in MCU processor and digital addressing

• 24VDC/2A Output relay contact and Control module

• Input Fire or Supervisory signal configuration

• LED status indicator

• Onsite Adjustable Parameter

• Loop or external power input

•  Aesthetically pleasing design

• Surface mounting with fix base for simple installation

Listed : LPCB Pending

Compliance : EN54-18:2005/AC2007

Power Rating

Input Voltage : Loop Power:24VDC [16V to 28V] External PSU: 20 to 28VDC

Current Consumption : Loop: Standby 0.6mA, Alarm: 2.1mA

External PSU: Standby 1.5mA, Alarm: 9.0mA

Control output voltage : 24VDC / 2A rating

Module

Protocol/Addressing : T&A, Value range from 1 to 254

Indicator Status : Normal:Fault Blink

Active:Output Activation Steady

Fault:Fault Steady

Material / Colour : ABS / White Glossy finishing

Dimension / LWH : 108 mm x 86 mm x38 mm

Weight : 160g (with Base), 89g (without Base)

Operating Temperature : -10°C to +50°C

Ingress Protection Rating : IP30

Humidity : 0 to 95% Relative Humidity, Non condensing