How To Program Intelligent Fire Alarm System

Views: 2240 Author: Site Editor Publish Time: Origin: Site

The majority of fire alarm panels today can be programmed using the manufacturer's software or the buttons on the front panel.

Technical help from the manufacturer should be contacted because fire alarm systems come in a variety of makes and models.

You will discover how to set up an intelligent fire alarm system in this article.

How Do You Program Fire Alarm System

To begin with, each type of fire alarm system has a unique programming scheme. There isn't a single informational source that I am aware of that will address them all.

Detect a warn

The purpose of the fire alarm system is to warn people of the fire and detect fire. The fire alarm system does not get programmed in the box on the wall.

The detector’s pull stations, input switches, strobes, horns, and relays spread throughout the structure make up the actual fire alarm system.

Only the fire alarm system is controlled via the Fire Alarm Control Panel (FACP), which is where the majority of programming takes place.

The FACP is instructed on how to operate the system by the program you write. The program mainly functions as plug-in descriptors for:

  • Types of input.
  • Output formats.
  • Displaying alphanumeric strings for the firemen.
  • Organizing.
  • Internal guidelines.
  • You'll need to be fully knowledgeable about the building's fire alarm system to know what to plug into the boxes.

Sequence of operation

You must program the order of operations once the data regarding the inputs, outputs, and housekeeping has been plugged in.

The actual process of programming a series of operations will differ greatly across manufacturers and frequently between models even within the same manufacturer. You must read the programming manual that is included with the system you are using.

There is a rule like this for each input device inside the fire alarm panel. Although some panels have additional phases, the fundamental principle is still in place.

The laptop will make it simpler to build up the operation's sequences, compile them all, and then download the entire set of rules into the panel. But since every fire alarm system model seems to be unique, the best advice I can give is to "read the programming instructions".

TX24-10A Intelligent Power Supply Unit

Special note about messages

Messages, which are alphanumeric strings of characters, are one of the input and output boxes. There is one for each input and output. The strings allow service professionals, building management staff, and firefighters to view what the panel is seeing.

The string is displayed every time the fire panel shows a device address number.
The string that goes with a specific address doesn't matter, whether it be "The glacier careened down the canyon" or "Smoke 1st Floor near Apartment 101."

As a programmer, keep in mind that you are the one who enters the string of text that the firefighters will read in an emergency.

Frequently, these are volunteer firefighters. They won't comprehend terms like RTU (Roof Top Unit; why not just say Roof Top HVAC?) or AFA (Automatic Fire Alarm; why not just say Smoke Detector?). Try to speak in terms that your sister can comprehend.

Contact Us For Your Superior Fire Alarm System

The programming guides for each model must primarily be consulted. Typically, the program is simple to use and self-explanatory.

Please contact us for your fire alarm system and our technical support department.

×

Contact Us

captcha
×

Inquire

*Name
*Email
Company Name
Tel
*Message